SON Edelux II LED headlight - with Coaxial Adapter
SON Edelux II LED headlight for dynamo hubs with coaxial adapter and male coaxial connector fitted.
The coaxial adapter makes plugging/unplugging the headlight easier and relieve stress on the hub connectors.
- Integrated capacitor allows 4min of bright standlight when you stop.
- More than 100 lux brightness.
- Sensor mode automatically switches the light on.
- Works with or without tail light.
- Compatible with any 6V AC dynamo.
- 49mm diameter
- 85g
- Comes with steel wire bracket, coaxial adapter and male coaxial connector fitted.
- Made in Germany, 5 years warranty
You might also like
Customers who bought this product also bought:
€342.00
SON 28, 15mm thru axle, width 110mm (boost standard), disc 6-bolt
€32.20
Pair of aluminum stays for 60mm wide fenders.
Connectors, cable and heat shrink tubing
Crimp Connectors 2,8 x 0,5 mm, Spade female, pack of 100 pcs
229SON72121
€16.00
€80.00
SON rear light - seatpost mount
- Fits tubes from 26 to 31.8mm.- Aluminum housing- Potted electronics and lens- 190cm cable with bare ends- connectors enclosed- 35g w/o cable- Made in Germany- 5 years warranty
€18.00
Allows conversion of all SON hubs for 12mm through axle to 9mm axle.
€3.70
Necessary hardware to mount fender stays on fenders.Are included :- 4 x BHC M4x10 screws- 4 x M4 nylstop nuts- 4 x ø4x16 washers
€79.45
Our classic polished stainless steel fenders.Pre-drilled (except for seatstay bridge), hardware and fender stays included (L bracket for unthreaded seatstay bridge or carbon fork sold separately).
For tires up to 26” x 1.25”
€79.45
Our classic polished stainless steel fenders. Pre-drilled (except for seatstay bridge), hardware and fender stays included (L bracket for unthreaded seatstay bridge or carbon fork sold separately).
Will fit tires up to 27.5" x 2.3" if your frame allows to mount the fender at a minimum of 15-20mm above the tire.